ALTAI C1N SUPER WIFI CPE/AP ALATI Point d'accès C1an Super WiFi CPE/ AP (EU) IEEE 802.11 a/n 2.4GHz, AP / CPE, Puissantes antennes intégrées Antennes directionnelles 14 dBi, Intègre un mécanisme d’alignement composé de 8 LED pour une installation simple, rapide et performante, Boîtier étanche Compatible IP 55

Prix : 1.390,00 Dhs
Autres vues du produit

Altai C1an Super WiFi CPE/AP

The Altai C1an WiFi CPE/AP is designed as an essential component in the Altai Super WiFi system to extend outdoor Wi-Fi coverage into indoor areas for broadband connectivity in 5 GHz band or use

as an AP for pico coverage.




The Altai C1an employs patented smart signal processing algorithms and antenna design to increase Wi-Fi signal strength (transmit and receive) by as much as 18 dB in areas covered by an A8n Super WiFi Base Station or A2 WiFi Access Point. It can be installed exactly where the throughput is required to boost up, and it allows the service operator to increase the coverage range of an

A8n base station substantially and provides greater flexibility and cost savings to Wi-Fi deployments.



Max. LOS Access

1 km/ext. (5 GHz)



4 km to A8-Ein(ac)

3 km to A3-Ei

Max. LOS Bridge

13 km

Max. Data Rate

300 Mbps


Super Long Range Coverage


Control Traffic Throughput Flexibly

From day one, the C1an is designed and

purpose-built for carriers. Its built-in traffic shaping based bandwidth control mechanism allows the control of uplink and downlink traffic throughput on a per-client or per-VAP basis. A full set of networking and management features are available to meet carriers’ requirements.



Altai C1an for Wireless Broadband

The C1an is a key component in wireless broadband access provisioning. It can be installed outdoor by the side of a window,

mounted to a wall, at the rooftop of a building or placed at the desktop inside for fixed broadband access provisioning.


Altai C1an for Access Point

The C1an can also be used as a standalone Wi-Fi access point for smaller networks operating at 5

GHz with fast Ethernet backhaul. With its high gain built-in smart antenna, it is an important solution to complement the large coverage and high throughput of an A8n Base Station and A2

Access Point to improve Wi-Fi performance.


Altai C1an for PTP Bridge

The C1an is perfect for use as low cost point-to- point bridge, in deployment scenarios such as commercial wireless broadband users or high definition surveillance cameras.



As an integral part of our Super WiFi network infrastructure, the Altai C1an differentiates others with:


Ÿ Features built-in for carriers including per

client/VAP based bandwidth control, remote

web-based management and client association status


Ÿ ±45° dual slant patch antennas are optimized to match with the Altai A8n/A2 antennas. It provides 3 dB more gain as compared to other V/H polarized CPEs


Ÿ High performance antenna with 20 dB front-to- back ratio, which is on average 5 dB better than others in directional transmission without picking up unwanted signal

Ÿ One-piece weatherproof chassis compliant to

IP55 standard for direct outdoor installation


Ÿ 8-level LED for easy alignment in the strongest signal direction


Ÿ Increase signal strength for both NLOS and LOS

coverage areas


Ÿ Improve data transmission rate and throughput utilization of base station




Wireless Interface

802.11a/n (2x2) Radio

·  Operating Mode                   AP/ CPE/ Bridge/ Repeater

·  Standard                                  IEEE 802.11a/n

·  Operating Frequency          5.150 – 5.350 GHz

5.470 – 5.725 GHz

5.725 – 5.850 GHz

·  Transmit Power                       29 dBm (Max.)

26 dBm (Per Chain)

·  Receiver Sensitivity

802.11a         54 Mbps            -83 dBm

6 Mbps              -96 dBm

802.11n         HT20                   -95 dBm

HT40                   -91 dBm

·  16 SSID (Max.)

·  802.11h*, 802.11k*, 802.11r*, 802.11v*, 802.11w*

·  Hotspot 2.0

·  Altai AirFi™ Throughput Optimization

·  Band Steering

·  WMM (802.11e)


Ÿ Built-in 5 GHz Antenna          14 dBi Dual Slant ±45° Sector

Ÿ Horizontal Beamwidth         35 - 45° (-3 dB)

Ÿ Vertical Beamwidth             15 - 20° (-3 dB)

Ÿ Front-to-back Ratio               -20 dB (Max.)


·  Switch (Bridge) and Gateway Mode

·  IPv4/ IPv6 Dual-stack

·  NAT

·  DHCP Client/ Server

·  PPPoE Client

·  VPN (IPsec)*


·  Bandwidth Control Per VAP/ Client

·  Multicast Rate Filter/IGMP Snooping



·  Authentication – Open system, Shared key, WPA/ WPA-PSK,  WPA2/ WPA2-PSK, 802.1x (EAP-PEAP/ TLS/ TTLS/ SIM/ AKA)

·  Encryption – WEP, TKIP, AES

·  Inter/ Intra-client Isolation

·  MAC-based Access Control (White/ Black List)


·  Active directory

·  Firewall*

·  WIPS*



·  Cloud or Server-based Management by AltaiCare

·  Controller-based Management by Access Controller

·  Web User Interface

·  Command Line Interface (SSH)

·  SNMP v1/ v2c / v3*

·  MIB2/ IF-MIB/ Altai Enterprise MIB

·  Syslog

·  Auto Channel Selection and TX Power Control

·  Spectral Analysis*

·  KPI Monitoring*

·  Client OS Detection*


Physical Specification

·  Dimension                               242 x 80 x 27 mm

(excluding mounting)

·  Weight                                      0.4 kg

·  Mounting                                  Desktop, Pole, Wall or


·  Network Interface                 10/100 Mbps Ethernet Port

·  LED Display                              Main Power Status

Ethernet Status

8-level Signal Strength

Power Supply                    (User configurable)


·  Power Supply                          18V Passive PoE PD or 802.3af

PoE PD via Adapter

·  Power Consumption            6 W (Typical) / 8 W (Max.)

Environmental Specification

·  Operating Temperature     -20 °C to +55 °C

·  Storage Temperature          -40 °C to +80 °C

·  Humidity                                   5 – 95% (Non-condensing)

·  Wind Loading                         Up to 200 km/h (124 mph)

·  Weatherproof                        Outdoor UV Stabilized Plastic

IP55 Compliant





·  FCC / CE / Others*


Product Ordering Information


Standard Package

Ÿ C1an Super WiFi CPE/AP with Built-in 5 GHz Patch

Antennas (Model No.: WA1011N-A)

Ÿ Cable Ties


Ÿ DC Injector and AC Adapter

Ÿ 802.3af to Passive PoE Adapter